Green-air-products Carbon Dioxide Generator Gas Conversion User Manual download pdf

1. Hose to pipe adapter

2. Safety valve

3. Thermocouple

4. Pilot burner head

5. Pilot orifice

6. Solenoid valve

7. Burner orifice

8. Thermocouple retainer clip

9. 3/8 thermocouple lead

10. Assembly mounting bracket

11. Solenoid wires

Basic Valve Assembly

(Typical model CD-3)

Carbon Dioxide Generator Gas Conversion Instructions

1. Lay generator on its right side with bottom toward you. Remove bottom plate by removing

phillips-head screws.

2. Remove the two screws and nuts holding the valve assembly mounting bracket to the left

housing side piece.

3. Remove the housing left side screws, front and back, and lift side off with burners

attached.

4. Unscrew 3/8” fitting on thermocouple lead where attached to bottom of the safety valve.

5. Remove retainer clip on top of the thermocouple. Lower thermocouple out of the pilot

head. Unscrew pilot head while holding pilot orifice with 1/2 end wrench. Remove pilot

orifice while holding pipe securely with pipe wrench. Re-install new pilot orifice using pipe

sealant (Loctite 565 is recommended).

6. Remove the existing brass burner orifice(s) from burner pipe or manifold and install the

new burner orifices using pipe sealant (do not use Teflon tape).

7. Re-install the pilot head keeping it in line with valve body, even if you have to turn one

more time full turn to get it tight. Re-install thermocouple to pilot head and safety valve.

8. Install side of housing and then the two screws and nuts for the valve assembly mounting

bracket. Fasten bottom plate back in position.

9. Install the proper pressure regular for the gas being used, either to propane tank or

incoming gas service supply line.

10. With gas “On” and switch “Off” test all fittings for leaks using soapy water (25% liquid dish

soap to 75% water). Bubbles will appear if leaks are present.

Basic Valve Assembly 1

Summary of Contents

Page 1 - Basic Valve Assembly

1. Hose to pipe adapter2. Safety valve3. Thermocouple4. Pilot burner head5. Pilot orifice6. Solenoid valve7. Burner orifice8. Thermocouple retainer cl

Comments to this Manuals

No comments

Green-air-products Carbon Dioxide Generator Gas Conversion User Manual

Browse online or download User Manual for Gardening equipment Green-air-products Carbon Dioxide Generator Gas Conversion. Green Air Products Carbon Dioxide Generator Gas Conversion User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Gardening equipment Green-air-products Carbon Dioxide Generator Gas Conversion